CADB/T-HE PRO-REG Series
CADB-T-HE-PRO-REG
Configurable and airtight supply and exhaust spigots, suitable for horizontal installation.
Applications
Commercial premises, offices, restaurants, public buildings, schools.
CADB/T-HE D PRO-REG
Heat recovery units without additional incorporated heater.
CADB/T-HE DI PRO-REG
Heat recovery units with built-in electric heater battery.
CADB/T-HE DC PRO-REG
Heat recovery units with built-in low pressure hot water coil.
The 3-Way valve is provided as an accessory (see accessories table for this series)
Motors
Models 04 to 21: EC motors with integrated electronic protection, IP44, Class B.
Models 40 and 54: Three phase motors, IP55,Class F.
Fans
Plug-fan with backward curved impeller.
All fans installed in CADB/T- HE PRO-REG models, comply with the efficiency requirements of the ErP Directive.
Filters
- F7: Low pressure F7 filters for supply air.
-M5: M5 filters for extract air.
Control
It includes manual or automatic control for modes: adjustable airflow (VAV), constant pressure (COP) or constant airflow (CAV), via CO2, pressure or airflow sensors (accessories).
Post-heating stage versions (-DI/-DC) allow post-heating management depending on the temperatures taken by the temperature probes incorporated in the design.
Ranges of product according to the type of operating control:
VAV- variable air volume
Fan speed can be adjusted with a 0 - 10V signal from the remote touchscreen panel (included) or an external CO2, temperature or humidity sensor (accessories).
CAV - constant air volume
Manual pre-setting of 2 working points the fans are controlled separately. It is necessary to add two pressure sensors TDP-D as external accessory.
COP - constant pressure
Constant pressure measured by an external pressure sensor TDP-S (accessory). It is necessary to add a pressure sensor TDP-S as an external accessory*.
* To control supply and extract air separately it is necessary to install 2 pressure sensors TDP-S.
Additional information
Single phase (CADB-HE PRO-REG) and three phase models (CADT-HE PRO-REG). Airflows from 400 to 5400 m3/h at 150 Pa of static pressure available.
All versions and models include by-pass. Mounting flexibility provided by the interchangeable side panels.
Attributes

Remote control panel
Maximum wire distance 50 m.
Connection wire not included.

Security switch
All versions include a On/Off security device.

Low noise level and robust construction
Casing with double skinned 25 mm panels with thermoacoustic flameproof insulation M0, with high-quality finish and plastic corners.

PRO-REG Controller
Mounted in an IP54 weatherproof electrical box.

High-efficiency motors
Incorporating Plug-fans with EC single-phase motor.

Bypass
All versions include internal bypass (approximately 75% airflow).

Counterflow heat exchanger
high-efficiency (up to 93%), EUROVENT certified.

High-efficiency filters
-F7 Filters: Low pressure F7 filters for supply air.
-M5 Filters: M5 filters for extract air. Possibility of mounting a second filter (accessory).

Support
Specific supports to allow installation in false ceilings via threaded rods.